; G-Code generated by Matthew Upp of GigDigit.com
; Revised 19:39 Tuesday, October 6, 2020
;
; Load firmware default settings and save to EEPROM
;
; This gcode file will work with the following 3D printers:
; Malyan - M100, M200, M310, M300, M320, MA10, MA10 Mini
; Monoprice - MP10, MP10 Mini, MP Mini Delta, MP Select Mini
;
;
; This file is much longer than it needs to be but is like this to 
; show what is going on.
;
; Lines with only a semicolon are for making line separations only.
;
; If when "printing" this file it does not show as completed on the 
; display but the fan pulsed on and off a few times then the firmware 
; was set to default settings and you can turn the printer off and on 
; to make the new (default) settings active.
;
;
; BEGIN
M107 ; turn fan off in case it was already on
M106 S200 ; turn fan on to signify start
;
;
; The next two lines are the only actual commands that are needed to
; reset the firmware to default settings and save.
M502 ; reset eeprom to firmware default settings
M500 ; save the settings to eeprom
;
;
; PULSE FAN TO SIGNIFY COMPLETION
M107 ; turn fan off
G4 S1 ; wait 1 second
M106 S255 ; fan at full speed
G4 P500 ; wait 0.5 seconds
M107 ; fan off
;
G4 P250 ; wait 0.25 seconds
M106 S255 ; fan at full speed
G4 P500 ; wait 0.5 seconds
M107 ; fan off
;
G4 P250 ; wait 0.25 seconds
M106 S255 ; fan at full speed
G4 P500 ; wait 0.5 seconds
M107 ; fan off
;
G4 P250 ; wait 0.25 seconds
M106 S255 ; fan at full speed
G4 P500 ; wait 0.5 seconds
M107 ; fan off
;
G4 P250 ; wait 0.25 seconds
M106 S255 ; fan at full speed
G4 P500 ; wait 0.5 seconds
M107 ; fan off
;
G4 P250 ; wait 0.25 seconds
M106 S255 ; fan at full speed
G4 P500 ; wait 0.5 seconds
M107 ; fan off
;
;
M400 ; wait for current moves to finish
M107 ; turn fan off to signify completion
M84 ; disable motors
; END