User Tools

Site Tools


extended_g-code_table

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
extended_g-code_table [2018/06/24 01:13]
Matthew Upp [M561 - Change Hotend Thermistor Type]
extended_g-code_table [2018/09/15 07:51]
Matthew Upp
Line 50: Line 50:
 ==== M561 - Change Hotend Thermistor Type ==== ==== M561 - Change Hotend Thermistor Type ====
 === Default === === Default ===
-<file gcode change_hotend_thermistor_type_104gt-2.gcode>+<file gcode change_hotend_thermistor_type_default.gcode>
 ; G-Code generated by Matthew Upp ; G-Code generated by Matthew Upp
 ; Change thermistor type to Default or EPCOS 100K and saves to EEPROM ; Change thermistor type to Default or EPCOS 100K and saves to EEPROM
Line 103: Line 103:
 Reboot printer to complete the process Reboot printer to complete the process
 </​code>​ </​code>​
 +
 +==== M562 Z ====
 +<file gcode invert_z-axis.gcode>​
 +; G-Code generated by Matthew Upp
 +; Invert Z-Axis ​
 +; for Malyan M200 & MP Select Mini
 +
 +; Lines with only a semicolon are for making line separations only
 +; Please add a blank line to the end of the file while editing. DokuWiki Code Blocks deletes blank lines at the end of the block but g-code files should end with a single blank line at the end.
 +
 +
 +M106 S1 ; turn fan off in case it was already on
 +M0 S2 ; wait 2 seconds
 +M106 S245 ; turn fan on to signify start
 +
 +;  ​
 +M562 Z ; Invert Z-Axis
 +M500 ; Save currently loaded settings to EEPROM
 +
 +;
 +G28 Z ; home Z to verify the Z-axis is inverted
 +G1 Z10 F1000 ; Move Z-Axis up 10mm to signify completion
 +M107 ; turn fan off to signify completion
 +M84 ; disable motors
 +M0 S2 ; wait 2 seconds
 +;
 +; You may need to reboot the printer to complete the process
 +</​file>​
  
 ---- ----
extended_g-code_table.txt · Last modified: 2018/12/22 04:16 by Matthew Upp