This is an old revision of the document!
These are not complete or official changelogs. As of this writing there isn't one.
- Modified heater runaway protection. If heating and sensor reading not changing after 30 second, will stop heating and (should) halt. (Something appears to have been happening when printing via USB that caused the nozzle temperature to continuously rise. Cause unknown but doesn't appear to have been a firmware bug that caused the temperature increase.)
- Fix cancel procedure. - (when pressing cancel twice during pre-heat, the printhead would start moving which required the MPSM V2 to be switched off)
- Fixed some USB compatibility issue with Linux/MacOSX system. Cura 15.##.# and Repetier-Host working on macOS. Cura 2.# and Simplify3D on macOS may not connect.
- Minor bug fix.
- Add Mirror function which is intended for another model. The designed Y gantry is mirrored, so we can use M562 MY command to mirror Y axis.
M562 to mirror axis.
-A: If connection of X motor is wrong, caused motor direction inverted. Use “M562 X” to invert direction.
-B: If printed object is mirrored, you want to print letter “d” but get letter “b”. In this case, you need to install endstop to opposite end and invert motor. So use “M562 MX”, firmware will set coordinate to MAX when homing.
- Option to use a different type of thermistor on the heat bed. Added a few more thermistors options to the list of potential replacement thermistors.
M561 - Heat bed thermistor type
“M561 B P1” or “M561 B P0”
- Add: M561 - Change thermistor type
“M561 P1” or “M561 P0”
- Fixed file reading error, software will retry open and read file again, but file pointer set to 0 by mistake causing printing progress jump back to 0.
- Enabled fan header for main board cooling
(no date or download available)
- Unknown \\D
- Reopen file if there was a SD card read error.
- PID parameters updated
- M303 (PID Autotune) connection lose bug fixed. If command M303 was sent printer froze or lost connection requiring the printer to be power cycled. - PID Autotune still didn't work well.
(2016-JUN-09 - date first made available)
- Solved heated bed setting (unknown exactly what the fix did)
- Add the ability for the user to upload a custom Web UI.
- M566 - Rename cache file
(2016-AUG-16 - unreleased)
- Added web-socket interface, use browser to access printer using WebSocket. This will allow faster communication with the printer using a web browser.
- Bug fix - Fixed delay when WiFi connected.
- Changed cursor color to red.
- Updated Web UI - added buttons and temperature control / monitors. Version 33 only had an option to upload g-code.
- Bugs fixes
- WiFi made available
- First implementation of Web UI