User Tools

Site Tools


firmware:motion_controller

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
firmware:motion_controller [2018/12/05 21:58]
Matthew Upp
firmware:motion_controller [2019/09/28 10:40] (current)
Matthew Upp
Line 98: Line 98:
 <wrap lo>//​(Use this version only if your printer came with v34 or higher.)//</​wrap>​ \\ <wrap lo>//​(Use this version only if your printer came with v34 or higher.)//</​wrap>​ \\
 [[https://​mpselectmini.com/​firmware/​changelog#​v41|Changelog v41]] \\ [[https://​mpselectmini.com/​firmware/​changelog#​v41|Changelog v41]] \\
 +----
 +
 +==== Pro/V3 firmware ====
 +**[[https://​mpselectmini.com/​_media/​firmware/​motion/​mpsm_pro_-_motion_v50_-_2018-07-12.zip|v50 - Motion Controller firmware for MPSM Pro/V3]]** \\
 +<wrap lo>//I prefer v50 because the bed leveling probe points are further from the center of the bed. v51 for some reason probes 4 points in a small square near the center of the build plate. v51 is not available for download.//</​wrap>​ \\
 +[[https://​mpselectmini.com/​firmware/​changelog#​v40|Changelog v50]]
 +
  
 </​WRAP>​ </​WRAP>​
firmware/motion_controller.txt · Last modified: 2019/09/28 10:40 by Matthew Upp