User Tools

Site Tools


Sidebar


User's Manual & Quick Start Guide

Specifications

Where to Purchase

Donations & Support

Replacements Parts & Information

Mods & Improvements

How-to

OctoPrint

Slicer Stuff

Troubleshooting

Maintenance

WiFi

Web UI

Firmware

Downloads

Donations & Support


Amazon Affiliate Program Disclosure

Looking for the Monoprice MP Mini Delta Wiki?

firmware:ui_controller

This is an old revision of the document!


Updating UI Controller Firmware

Link to firmware: https://goo.gl/YTwBs9

  1. Disconnect USB cable
  2. Copy the lcd.bin file to the micro SD card and put into printer while powered off
  3. Slide the x carriage all the way to the end stop making sure the endstop stays depressed.
  4. Slide the bed all the way to the end stop making sure the endstop stays depressed.
  5. Press and hold the dial in.
  6. While still keeping the dial button depressed, power on the printer.
  7. Keep the dial depressed until the cooling fan on the hotend turns on and then release the dial.
  8. The LCD will stay black until the update process is finished which is about one minute of less.

Update not starting? Fan doesn't start spinning?

  • If the fan doesn't come on, check to make sure the x and y end stops are depressed.
  • Verify the USB cable is disconnected from the printer
  • Try updating the motion controller firmware first. Older firmware version had problem updating the UI controller firmware.

YouTube link: https://youtu.be/8nELO68ueNY - Updating UI Controller firmware

firmware/ui_controller.1470204152.txt.gz · Last modified: 2016/08/10 19:52 (external edit)