User Tools

Site Tools


User's Manual & Quick Start Guide


Where to Purchase

Donations & Support

Replacements Parts & Information

Mods & Improvements



Slicer Stuff




Web UI



Donations & Support

Amazon Affiliate Program Disclosure

Looking for the Monoprice MP Mini Delta Site?


This is an old revision of the document!

Updating UI Controller Firmware

Link to firmware:

  1. Disconnect USB cable
  2. Copy the lcd.bin file to the micro SD card and put into printer while powered off
  3. Slide the x carriage all the way to the end stop making sure the endstop stays depressed.
  4. Slide the bed all the way to the end stop making sure the endstop stays depressed.
  5. Press and hold the dial in.
  6. While keeping the dial button depressed, power on the printer. Keep the dial depressed until the cooling fan on the hotend turns on and then release the dial.
    The LCD will stay black until the update process is finished which is about one minute or less.
  7. Restart Printer

Update not starting? Fan doesn't start spinning?

  • If the fan doesn't come on, check to make sure the x and y end stops are depressed.
  • Verify the USB cable is disconnected from the printer
  • Try updating the motion controller firmware first. Older firmware version had problem updating the UI controller firmware.

YouTube link: - Updating UI Controller firmware

firmware/ui_controller.1471851853.txt.gz · Last modified: 2016/08/22 07:44 by Matthew Upp