User Tools

Site Tools


Sidebar


User's Manual & Quick Start Guide

Specifications

Where to Purchase

Donations & Support

Replacements Parts & Information

Mods & Improvements

How-to

OctoPrint

Slicer Stuff

Troubleshooting

Maintenance

WiFi

Web UI

Firmware

Downloads

Donations & Support


Amazon Affiliate Program Disclosure

Looking for the Monoprice MP Mini Delta Wiki?

firmware:ui_controller

This is an old revision of the document!


Updating UI Controller Firmware

Link to firmware: https://goo.gl/YTwBs9

  1. Disconnect USB cable
  2. Rename lcd_Ver##.bin to lcd.bin
  3. Copy the lcd.bin file to the micro SD card and put into printer while powered off
  4. Move the x-axis (x-carriage) all the way to the left making sure the endstop stays pressed in.
  5. Slide the y-axis (bed) all the way to the back making sure the endstop stays pressed in.
  6. Press and hold down the control dial/button
  7. While keeping the control dial/button pressed down, power on the printer. Keep the control dial/button pressed down until the fan on the hotend starts spinning (about 3-5 seconds).
    The LCD will stay black until the update process is finished which is about one minute or less. The LCD will turn on when the update is complete.
  8. Restart Printer
  9. Delete lcd.bin from micro SD card if printer keeps restarting.

Update not starting? Fan doesn't start spinning?

  • If the fan doesn't come on, check to make sure the x and y endstops are pressed in.
  • Verify the USB cable is disconnected from the printer
  • Try updating the motion controller firmware first. Older firmware version had problem updating the UI controller firmware.

YouTube link: https://youtu.be/8nELO68ueNY - Updating UI Controller firmware

firmware/ui_controller.1472311346.txt.gz · Last modified: 2016/08/27 15:22 by Matthew Upp