User Tools

Site Tools


Sidebar


User's Manual & Quick Start Guide

Specifications

Where to Purchase

Donations & Support

Replacements Parts & Information

Mods & Improvements

How-to

OctoPrint

Slicer Stuff

Troubleshooting

Maintenance

WiFi

Web UI

Firmware

Downloads

Donations & Support



Looking for the Monoprice MP Mini Delta Wiki?

howto:bowden_tube_removal

Bowden Tube Removal


  • Push down on the blue collar while pulling up on the Bowden tube.
  • Be mindful of the wiring, mainly the thermistor wiring.

NOTE: Removing the Bowden tube from the hotend on a V2 may be difficult. If you must remove the Bowden tube it may be easier to unscrew the connecter from the heat sink and cut the end of the Bowden tube as close as you can. Then remove the cut piece Bowden tube and push through connector.


Bowden Tube Removal


Sorry about the portrait mode. Hopefully this will be a temporary video to be replaced with something a tad bit better. Hopefully.


Bowden Tube Connector Removal


The “set screw” or “grub screw” takes a 1.5mm or 1/16“ Allen wrench.

howto/bowden_tube_removal.txt · Last modified: 2017/10/10 02:10 by Matthew Upp