User Tools

Site Tools


howto:bowden_tube_removal

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
howto:bowden_tube_removal [2017/05/25 08:46]
Matthew Upp created
howto:bowden_tube_removal [2017/10/10 02:10]
Matthew Upp
Line 1: Line 1:
 +~~NOTOC~~
 +
 ====== Bowden Tube Removal ====== ====== Bowden Tube Removal ======
  
 ---- ----
  
-Push down on the blue collar while pulling up on the Bowden tube.+  * Push down on the blue collar while pulling up on the Bowden tube
 +  * Be mindful of the wiring, mainly the thermistor wiring.
  
-Be mindful ​of the wiring, mainly ​the thermistor wiring.+**NOTE:** Removing the Bowden tube from the hotend on a V2 may be difficult. If you must remove the Bowden tube it may be easier to unscrew the connecter from the heat sink and cut the end of the Bowden tube as close as you can. Then remove ​the cut piece Bowden tube and push through connector. 
 + 
 +---- 
 + 
 +<WRAP group> 
 +<WRAP half column>​ 
 +===== Bowden Tube Removal ===== 
 +{{youtube>​NHcb14zSKjc?​medium}} \\
  
 <wrap lo>Sorry about the portrait mode. Hopefully this will be a temporary video to be replaced with something a tad bit better. //​Hopefully.//</​wrap>​ <wrap lo>Sorry about the portrait mode. Hopefully this will be a temporary video to be replaced with something a tad bit better. //​Hopefully.//</​wrap>​
Line 11: Line 21:
 ---- ----
  
-===== Video ===== +</​WRAP>​ 
-**Bowden Tube Removal** \\ + 
-{{youtube>​NHcb14zSKjc?medium}}+ 
 +<WRAP half column>​ 
 + 
 +===== Bowden Tube Connector Removal ​===== 
 +{{youtube>​k4GGCW7rKTk?​medium}} ​\\ 
 +//The "set screw" or "grub screw" takes a 1.5mm or 1/16" Allen wrench.//  
 + 
 +</​WRAP>​ 
 +</​WRAP>​
  
howto/bowden_tube_removal.txt · Last modified: 2017/10/10 02:10 by Matthew Upp