User Tools

Site Tools


howto:default_settings

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
howto:default_settings [2018/06/10 14:44]
Matthew Upp
howto:default_settings [2019/01/24 00:15]
Matthew Upp
Line 64: Line 64:
 ; G-Code generated by Matthew Upp ; G-Code generated by Matthew Upp
 ; Load firmware default settings and save to EEPROM ; Load firmware default settings and save to EEPROM
-; This file is much longer than it needs to be +; for Malyan M200 & MP Select Mini 
-;+; This file is much longer than it needs to be. It is like this to show what is going on 
 +
 ; Lines with only a semicolon are for making line separations only ; Lines with only a semicolon are for making line separations only
-; Please add a blank line to the end of the file while editing. DokuWiki Code Blocks ​deletes ​blank lines at the end of the block but g-code files should end with a single blank line at the end.+; Please add a blank line to the end of the file while editing. DokuWiki Code Blocks ​removes ​blank lines at the end of the block but g-code files should end with a single blank line at the end.
  
  
-M106 S0 ; turn fan off in case it was already on+M107 ; turn fan off in case it was already on
 M106 S245 ; turn fan on to signify start M106 S245 ; turn fan on to signify start
  
-G4 S2 ; Pause 2 seconds 
 ; ;
 M502 ; Reset EEPROM to firmware defaults M502 ; Reset EEPROM to firmware defaults
 M500 ; Save currently loaded settings to EEPROM M500 ; Save currently loaded settings to EEPROM
 ; ;
-G4 S2 ; Pause 2 seconds ​ 
-; 
-M106 S0 ; turn fan off to signify completion 
-M84 ; disable motors if engaged 
-M0 S2 ; wait 2 seconds 
 ; ;
 +G91 ; Set to relative positioning
 +G1 X6 F1000 ; Move X-Axis 6mm to the right
 +M400 ; Wait for current moves to finish
 +M107 ; turn fan off to signify completion
 +M84 ; disable motors
 +
 </​file>​ </​file>​
  
howto/default_settings.txt · Last modified: 2020/03/23 05:52 by Matthew Upp