User Tools

Site Tools


howto:default_settings

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
howto:default_settings [2017/11/17 07:44]
Matthew Upp
howto:default_settings [2019/01/24 00:15] (current)
Matthew Upp
Line 9: Line 9:
 See [[:​g-code#​sending_g-code|Sending G-code]] for more information on how to send the commands below. See [[:​g-code#​sending_g-code|Sending G-code]] for more information on how to send the commands below.
 \\ \\
 +
 +----
  
 ===== Restore Default Settings and Save ===== ===== Restore Default Settings and Save =====
Line 22: Line 24:
  
 Rebooting the printer may not be necessary but it is recommended. Rebooting the printer may not be necessary but it is recommended.
-\\ 
 \\ \\
  
 +----
  
 ===== Temporarily Restore Default Settings ===== ===== Temporarily Restore Default Settings =====
Line 42: Line 44:
  
 Most often the two settings altered by the users are the PID values and the Steps per mm for the extruder stepper motor. Most often the two settings altered by the users are the PID values and the Steps per mm for the extruder stepper motor.
-\\ 
 \\ \\
 +
 +----
  
 ===== Reset via WiFi ===== ===== Reset via WiFi =====
- 
 http://​printers_ip_address/​set?​code=M502 \\ http://​printers_ip_address/​set?​code=M502 \\
 http://​PRINTERS_IP_ADDRESS/​set?​code=M500 \\ http://​PRINTERS_IP_ADDRESS/​set?​code=M500 \\
Line 54: Line 56:
 http://​192.168.20.113/​set?​code=M500 http://​192.168.20.113/​set?​code=M500
 </​code>​ </​code>​
 +\\
 +
 +----
 +
 +===== Using gcode file =====
 +<file gcode load_fw_defaults_and_save_to_eeprom.gcode>​
 +; G-Code generated by Matthew Upp
 +; Load firmware default settings and save to EEPROM
 +; for Malyan M200 & MP Select Mini
 +; This file is much longer than it needs to be. It is like this to show what is going on
 +
 +; Lines with only a semicolon are for making line separations only
 +; Please add a blank line to the end of the file while editing. DokuWiki Code Blocks removes blank lines at the end of the block but g-code files should end with a single blank line at the end.
 +
 +
 +M107 ; turn fan off in case it was already on
 +M106 S245 ; turn fan on to signify start
 +
 +;
 +M502 ; Reset EEPROM to firmware defaults
 +M500 ; Save currently loaded settings to EEPROM
 +;
 +;
 +G91 ; Set to relative positioning
 +G1 X6 F1000 ; Move X-Axis 6mm to the right
 +M400 ; Wait for current moves to finish
 +M107 ; turn fan off to signify completion
 +M84 ; disable motors
 +
 +</​file>​
 +
howto/default_settings.1510904682.txt.gz · Last modified: 2017/11/17 07:44 by Matthew Upp