User Tools

Site Tools


howto:default_settings

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
howto:default_settings [2018/09/26 02:12]
Matthew Upp
howto:default_settings [2019/01/24 00:15] (current)
Matthew Upp
Line 65: Line 65:
 ; Load firmware default settings and save to EEPROM ; Load firmware default settings and save to EEPROM
 ; for Malyan M200 & MP Select Mini ; for Malyan M200 & MP Select Mini
-; This file is much longer than it needs to be+; This file is much longer than it needs to be. It is like this to show what is going on
  
 ; Lines with only a semicolon are for making line separations only ; Lines with only a semicolon are for making line separations only
-; Please add a blank line to the end of the file while editing. DokuWiki Code Blocks ​deletes ​blank lines at the end of the block but g-code files should end with a single blank line at the end.+; Please add a blank line to the end of the file while editing. DokuWiki Code Blocks ​removes ​blank lines at the end of the block but g-code files should end with a single blank line at the end.
  
  
-M106 S0 ; turn fan off in case it was already on+M107 ; turn fan off in case it was already on
 M106 S245 ; turn fan on to signify start M106 S245 ; turn fan on to signify start
  
-G4 S2 ; Pause 2 seconds 
 ; ;
 M502 ; Reset EEPROM to firmware defaults M502 ; Reset EEPROM to firmware defaults
 M500 ; Save currently loaded settings to EEPROM M500 ; Save currently loaded settings to EEPROM
 ; ;
-G4 S2 ; Pause 2 seconds ​ 
 ; ;
-M106 S0 ; turn fan off to signify completion+G91 ; Set to relative positioning 
 +G1 X6 F1000 ; Move X-Axis 6mm to the right 
 +M400 ; Wait for current moves to finish 
 +M107 ; turn fan off to signify completion
 M84 ; disable motors M84 ; disable motors
-M0 S2 ; wait 2 seconds +
-;+
 </​file>​ </​file>​
  
howto/default_settings.1537927964.txt.gz · Last modified: 2018/09/26 02:12 by Matthew Upp