User Tools

Site Tools


mainboard_cooling_fan

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
mainboard_cooling_fan [2017/01/08 18:23]
Matthew Upp
mainboard_cooling_fan [2017/08/15 05:11]
115.189.86.0 ↷ Links adapted because of a move operation
Line 1: Line 1:
 ~~NOTOC~~ ~~NOTOC~~
  
-===== Main Board Cooling Fan ===== +====== Mainboard ​Cooling Fan =====
-The unpopulated fan header is intended for a main board cooling fan that will start if the board temperature goes above 55C.+ 
 +<wrap em>**The MP Select Mini V2 ships with the mainboard cooling fan installed and enabled.**</​wrap>​ 
 + 
 +<wrap lo><​wrap em><​wrap hi>//The information below is intended for the original MP Select Mini (V1).//</​wrap></​wrap></​wrap>​ \\ 
 +The unpopulated fan header is intended for a mainboard ​cooling fan that will start if the board temperature goes above 55C.
  
 The first version of the boards that had the additional fan header will not work without a small hardware modification (the first version were sent out between August and September but no dates were actually given). The first version of the boards that had the additional fan header will not work without a small hardware modification (the first version were sent out between August and September but no dates were actually given).
  
-Per support team the fix requires "​reversing the small mosfet ​(SOT-23) upside down to make it correct"​. I ASSUME the one adjacent to the fan header. The "​design engineer made a mistake that reversed the package"​. ​+Per support team the fix requires "​reversing the small MOSFET ​(SOT-23) upside down to make it correct"​. I ASSUME the one adjacent to the fan header. The "​design engineer made a mistake that reversed the package"​. ​ 
 + 
 +The newest versions being shipped should have this correction already applied. A firmware update may also be required. Motion Controller Version 26 should support the fan header for the board cooling fan. 
 + 
 +[[firmware:​changelog#​v26|Changelog MC v26]] 
 + 
 +{{:​main_board_rev2_-_new_fan_header.jpg?​400|}} 
  
-The newest versions being shipped should have this correction already applied. A firmware update may also be required. Motion Controller Ver 26 should support the fan header for the board cooling fan. 
  
-http://​mpselectmini.com/​changelog#​v26 \\ 
  
-{{:​m200_main_board_rev2-new_fan_header.jpg?​500|}} 
mainboard_cooling_fan.txt · Last modified: 2017/08/15 05:11 by 115.189.86.0