optimal_layer

This shows you the differences between two versions of the page.

Both sides previous revision Previous revision | |||

optimal_layer [2017/05/10 03:02] Matthew Upp |
optimal_layer [2018/03/27 15:12] (current) Matthew Upp [Nitty-gritty] |
||
---|---|---|---|

Line 12: | Line 12: | ||

**Z-Axis Resolution** | **Z-Axis Resolution** | ||

- | So that motor [Z-Axis] is a 7.5°, 48 step motor as I just listed. Since the motor is attached to a M4 rod, which has a 0.7 mm thread pitch, then in one revolution makes the Z-Axis travel up or down 0.7 mm. Since it took 48 steps to turn that rev, each step is 0.00145833333333333333333333333333 etc etc mm. To avoid rounding errors, you can use multiple of 3 of this number, which is a nice and pretty 0.04375 mm. That is a nice and handy number that effectively represents the layer heights that mathematically work the best for layer heights for this printer. | + | So that motor [Z-Axis] is a 7.5°, 48 step motor as I just listed. Since the motor is attached to a M4 rod, which has a 0.7 mm thread pitch, then in one revolution makes the Z-Axis travel up or down 0.7 mm. Since it took 48 steps to turn that rev, each step is 0.0145833333333333333333333333333 etc etc mm. To avoid rounding errors, you can use multiple of 3 of this number, which is a nice and pretty 0.04375 mm. That is a nice and handy number that effectively represents the layer heights that mathematically work the best for layer heights for this printer. |

</blockquote> | </blockquote> | ||

\\ | \\ |

optimal_layer.txt · Last modified: 2018/03/27 15:12 by Matthew Upp

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International