User Tools

Site Tools


Sidebar


User's Manual & Quick Start Guide

Specifications

Where to Purchase

Donations & Support

Replacements Parts & Information

Mods & Improvements

How-to

OctoPrint

Slicer Stuff

Troubleshooting

Maintenance

WiFi

Web UI

Firmware

Downloads

Donations & Support



Looking for the Monoprice MP Mini Delta Wiki?

optimal_layer

This is an old revision of the document!


Optimal Layer Heights

Nitty-gritty

The following paragraph is an excerpt from Michael O'Brien's Hackaday project
Project: Monoprice Select Mini Electro-Mechanical Upgrades
Log: X, Y, Z, A Motors & Stepper Driver Investigation

Z-Axis Resolution

So that motor [Z-Axis] is a 7.5°, 48 step motor as I just listed. Since the motor is attached to a M4 rod, which has a 0.7 mm thread pitch, then in one revolution makes the Z-Axis travel up or down 0.7 mm. Since it took 48 steps to turn that rev, each step is 0.00145833333333333333333333333333 etc etc mm. To avoid rounding errors, you can use multiple of 3 of this number, which is a nice and pretty 0.04375 mm. That is a nice and handy number that effectively represents the layer heights that mathematically work the best for layer heights for this printer.


Actual Layer Heights

Using the information above we can put together a list of optimal layer heights ranging from 0.04375mm to 0.30625mm. We stop at 0.30625mm because with a nozzle diameter of 0.40mm, the maximum recommended layer height is 0.32mm.

Layer Height (mm)
0.04375
0.0875
0.13125
0.175
0.21875
0.2625
0.30625


More Info

optimal_layer.1482269276.txt.gz · Last modified: 2016/12/20 21:27 by Matthew Upp