User Tools

Site Tools


parts:hotend

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
parts:hotend [2018/08/13 15:30]
Matthew Upp
parts:hotend [2019/03/21 05:28]
Matthew Upp
Line 1: Line 1:
 +===== Direct Replacement =====
 +** Only for the V2's with the wire connector bundle inside the top of the tower. See the product pictures for examples. **
 +**GiGDigit** - **[[https://​gigdigit.com/​hotend-assembly-mp-select-mini-v2-short-wires/​|Hotend Assembly - MP Select Mini V2 (Short Wires)]]**
 +
 ====== Aftermarket Hotend Replacements ====== ====== Aftermarket Hotend Replacements ======
  
Line 7: Line 11:
  
 ** Autotune note ** \\ ** Autotune note ** \\
-Some of the options listed below will require updating the firmware'​s thermistor value using the custom G-code command [[:​extended_g-code_table#​m561_-_change_thermistor_type|"​M561 P1"]]. If you do change the thermistor type/value you will need to run [[:​pid_autotune|PID Autotune]]. If you are able to reuse the Select Mini's original thermistor it is STILL recommended to run [[:​pid_autotune|PID Autotune]]+//<wrap em>​Autotune may not work all that great so maybe the following about running autotune isn't going to work.</​wrap>// ​Some of the options listed below will require updating the firmware'​s thermistor value using the custom G-code command [[:​extended_g-code_table#​m561_-_change_thermistor_type|"​M561 P1"]]. If you do change the thermistor type/value you will need to run [[:​pid_autotune|PID Autotune]]. If you are able to reuse the Select Mini's original thermistor it is STILL recommended to run [[:​pid_autotune|PID Autotune]]
  
 ---- ----
parts/hotend.txt · Last modified: 2019/09/28 00:08 by Matthew Upp