User Tools

Site Tools


Sidebar


User's Manual & Quick Start Guide

Specifications

Where to Purchase

Donations & Support

Replacements Parts & Information

Mods & Improvements

How-to

OctoPrint

Slicer Stuff

Troubleshooting

Maintenance

WiFi

Web UI

Firmware

Downloads

Donations & Support



Looking for the Monoprice MP Mini Delta Wiki?

parts:microsd_card

microSD Card


Amazon.com - Kingston 8 GB microSDHC Class 4 Flash Memory Card SDC4/8GB
I ordered this card January 9, 2019 (and at least 6 more since then). shipped and sold by Amazon. I have successfully used this card directly out of the package with the MP Select Mini V2 and MP Mini Delta for printing with no formatting required. I have updated the motion controller firmware with this card but I have only tried a few times.

Amazon.com - Kingston Canvas Select 16GB microSDHC Class 10 microSD Memory Card UHS-I 80MB/s R Flash Memory Card with Adapter (SDCS/16GB)
I ordered this card March 10, 2019. shipped and sold by Amazon. I have successfully used this card directly out of the package with the MP Select Mini V2 and MP Mini Delta for printing with no formatting required. I have not tested if this card will work for updating the motion controller firmware.

Amazon.com - Kingston 2 GB microSD Flash Memory Card SDC/2GBSP (Single Pack)
This card seems to be either out of stock or overpriced more than it used to be. I guess I need to identify another known working card that is readily available.
I ordered this card December 14 from Amazon seller “i77e” to test after a number of people said they have used it without any issues.
I and others have had good luck with this and have successfully used this card directly out of the package with the MP Select Mini V2 and the MP Mini Delta for printing and also updating the Motion Controller firmware with no formatting required.


Try any card up to 32GB (yes some 32GB cards will work with the MP Select Mini V2 and the MP Mini Delta). FAT16 and FAT32 both work. Also exFAT works for some. The printer is picky about which cards it will read so if you have multiple microSD cards try them all.

You may also want to try formatting the larger cards such as 16GB and 32GB as FAT32 with different allocation unit/block sizes.

For example:

  • FAT32 with a block size of 4096
  • FAT32 with a block size of 8192
  • FAT32 with a block size of 16384
  • FAT32 with a block size of 32768
  • FAT32 with a block size of 65536

You can try the same with the lower capacity cards also but using smaller allocation unit/ block sizes. Also try FAT(16) with different allocation unit/ block sizes.


  • the printer heats up and never starts printing
  • the printer heats up and never starts printing but the progress bar continues to fill
  • the printer stops printing but the temps remain and the progress bar continues to fill
  • the printer goes through the starting script and then goes where it shouldn't (this could happen for other reasons also such as incorrect slicer settings)

Follow the link below for more information.
Printer Stops or Never Starts Printing

parts/microsd_card.txt · Last modified: 2019/04/24 18:51 by Matthew Upp