MP Select Mini / Malyan M200 (Unofficial) Wiki

User Tools

Site Tools

You are here: Welcome to the Unofficial Wiki for the MP Select Mini 3D Printer » parts » Set Screw and Square Nut for Holding the Heat Break and Bowden Connector

Sidebar

User's Manual & Quick Start Guide

Specifications

Where to Purchase

Donations & Support

Replacements Parts & Information

Mods & Improvements

How-to

OctoPrint

Slicer Stuff

Troubleshooting

Maintenance

WiFi

Web UI

Firmware

Downloads

Firmware, Software, Drivers, Profiles, etc...

Donations & Support

Looking for the Monoprice MP Mini Delta Wiki?

https://www.mpminidelta.com

parts:screws_heat_sink

This is an old revision of the document!

Screws for Heat Break and Bowden Connector.

The “set screw” or “grub screw” that holds the heatbreak and Bowden tube connector is M3x5 and takes a 1.5mm Allen wrench or 1/16“ Allen wrench.

parts/screws_heat_sink.1499145707.txt.gz · Last modified: 2017/07/04 05:21 by Matthew Upp

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
CC Attribution-Noncommercial-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki