User Tools

Site Tools


pid_tuning_ea

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Last revision Both sides next revision
pid_tuning_ea [2016/09/15 14:39]
Matthew Upp ↷ Page name changed from pid_tuning to pid_tuning_ea
pid_tuning_ea [2016/09/15 15:14]
Matthew Upp
Line 1: Line 1:
 ===== PID Tuning ===== ===== PID Tuning =====
 (by Ethan Anderson) (by Ethan Anderson)
 +
 +//(The information below applies mostly to Motion firmware 20 & lower)//
  
 The factory settings cause indefinite temperature swings of ±5ºC with a period of 60-80 seconds. M303 (PID auto-tune) causes the printer to crash/​reboot in firmware versions preceding 18.37. In 18.37 and later firmwares, M303 works, but the results are on par with the PID settings from the factory. ​ The stored value of the I parameter is 1000th of what it actually uses and autotunes to, therefor after M301 autotune you will need to manually reset the M301 I value to 1/1000th of what the autotune reports. The factory settings cause indefinite temperature swings of ±5ºC with a period of 60-80 seconds. M303 (PID auto-tune) causes the printer to crash/​reboot in firmware versions preceding 18.37. In 18.37 and later firmwares, M303 works, but the results are on par with the PID settings from the factory. ​ The stored value of the I parameter is 1000th of what it actually uses and autotunes to, therefor after M301 autotune you will need to manually reset the M301 I value to 1/1000th of what the autotune reports.
pid_tuning_ea.txt · Last modified: 2020/04/05 05:42 by Matthew Upp