User Tools

Site Tools


starting_ending_g-code_scripts

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
starting_ending_g-code_scripts [2017/12/27 05:04]
Matthew Upp
starting_ending_g-code_scripts [2019/10/19 01:44]
Matthew Upp
Line 20: Line 20:
 G1 Z0.2 F1200 ; raise nozzle 0.2mm G1 Z0.2 F1200 ; raise nozzle 0.2mm
 G92 E0 ; reset extrusion distance G92 E0 ; reset extrusion distance
-G1 Y10 ; move Y-Axis (bed) 10mm to prep for purge+G1 Y1 ; move Y-Axis (bed) 1mm to prep for purge
 G1 X100 E12 F600 ; move X-carriage 100mm while purging 12mm of filament G1 X100 E12 F600 ; move X-carriage 100mm while purging 12mm of filament
 G92 E0 ; reset extrusion distance G92 E0 ; reset extrusion distance
Line 44: Line 44:
 M84 ; disable motors M84 ; disable motors
 G4 S360 ; keep fan running for 360 seconds to cool hotend and allow the fan to be turned off - adjust to your needs G4 S360 ; keep fan running for 360 seconds to cool hotend and allow the fan to be turned off - adjust to your needs
-M107 ; turn off fan. Don't use M106 S1. Some say M107 doesn'​t work for them but if the hotend is below 70 degrees it should work+M107 ; turn off fan. Don't use M106 S1. Using M106 S1 may prevent the fan from turning on for the following print. Some say M107 doesn'​t work for them but if the hotend is below 70 degrees it should work
  
 </​file>​ </​file>​
starting_ending_g-code_scripts.txt · Last modified: 2019/10/19 01:44 by Matthew Upp