User Tools

Site Tools


wifi:start

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
Next revision Both sides next revision
wifi:start [2017/02/19 12:57]
Matthew Upp created
wifi:start [2017/11/24 08:48]
Matthew Upp
Line 1: Line 1:
 +~~NOTOC~~
 +
 ====== WiFi ====== ====== WiFi ======
 +
 +----
 +
 +
 +===== Connecting to WiFi =====
 +  * [[wifi:​android|Android - MP 3D Printer WiFi Connect]]
 +  * [[wifi:​ios|iOS - MP 3D Printer WiFi Connect]]
 +  * [[wifi:​g-code_file|G-code file]]
 +  * [[wifi:​g-code_usb|USB - G-code]]
 +  * [[wifi:​windows|Windows - Malyan Link]]
 +  * [[wifi:​android_3dcraft|Android - 3D Craft]]
 +
 +
 +===== Accessing Web UI =====
 +[[wifi:​webui|Accessing Web UI]]
 +
 +----
 +
 +==== NOTES: ====
 +
 +  * WiFi and USB cannot access simultaneously.
 +  * Disconnect USB cable from the printer if you want to use the WiFi function.
 +  * WiFi works with 2.4 GHz b/g/n networks only.
 +  * These next two notes apply to when connecting using the Android & iOS apps.
 +    - If you have a 2.4 GHz and 5 GHz network using the same SSID(wireless network name) you may have trouble connecting the printer.
 +    - For initial WiFi setup try moving the printer closer to the WiFi router.
 +
 +
 +**Link to firmware, Malyan Link (Windows PC), Malyan 3D Craft (Android):​** [[http://​f.mpselectmini.com|http://​f.mpselectmini.com]]
 +
 +---- 
 +===== Forget Network =====
 +While the MP Select Mini V1/V2 is connected to WiFi you may use the format **''​%%http://​PRINTERS_IP_ADDRESS%%''​** to send a single line of code g-code using a web browsers address/URL bar. See the examples in the following code block.
 +
 +**Format:** ''​%%http://​PRINTERS_IP_ADDRESS/​set?​cmd={W:​}%%''​ \\
 +<​code>​
 +http://​192.168.20.113/​set?​cmd={W:​}
 +</​code>​
 +
 +When the command is sent and received successfully the browser should display `OK` and the IP address should disappear from the LCD.
 +\\
 +
 +----
wifi/start.txt · Last modified: 2019/06/22 20:04 by Matthew Upp