User Tools

Site Tools


wifi:start

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
wifi:start [2017/02/19 14:49]
Matthew Upp
wifi:start [2017/11/24 08:48]
Matthew Upp
Line 1: Line 1:
 ~~NOTOC~~ ~~NOTOC~~
  
-====== Connecting to WiFi ====== +====== WiFi ====== 
-  * [[wifi:​android|Android - 3D Craft]]+ 
 +---- 
 + 
 + 
 +===== Connecting to WiFi ===== 
 +  * [[wifi:​android|Android - MP 3D Printer WiFi Connect]]
   * [[wifi:​ios|iOS - MP 3D Printer WiFi Connect]]   * [[wifi:​ios|iOS - MP 3D Printer WiFi Connect]]
   * [[wifi:​g-code_file|G-code file]]   * [[wifi:​g-code_file|G-code file]]
   * [[wifi:​g-code_usb|USB - G-code]]   * [[wifi:​g-code_usb|USB - G-code]]
   * [[wifi:​windows|Windows - Malyan Link]]   * [[wifi:​windows|Windows - Malyan Link]]
 +  * [[wifi:​android_3dcraft|Android - 3D Craft]]
  
  
Line 12: Line 18:
 [[wifi:​webui|Accessing Web UI]] [[wifi:​webui|Accessing Web UI]]
  
 +----
 +
 +==== NOTES: ====
 +
 +  * WiFi and USB cannot access simultaneously.
 +  * Disconnect USB cable from the printer if you want to use the WiFi function.
 +  * WiFi works with 2.4 GHz b/g/n networks only.
 +  * These next two notes apply to when connecting using the Android & iOS apps.
 +    - If you have a 2.4 GHz and 5 GHz network using the same SSID(wireless network name) you may have trouble connecting the printer.
 +    - For initial WiFi setup try moving the printer closer to the WiFi router.
 +
 +
 +**Link to firmware, Malyan Link (Windows PC), Malyan 3D Craft (Android):​** [[http://​f.mpselectmini.com|http://​f.mpselectmini.com]]
 +
 +---- 
 +===== Forget Network =====
 +While the MP Select Mini V1/V2 is connected to WiFi you may use the format **''​%%http://​PRINTERS_IP_ADDRESS%%''​** to send a single line of code g-code using a web browsers address/URL bar. See the examples in the following code block.
 +
 +**Format:** ''​%%http://​PRINTERS_IP_ADDRESS/​set?​cmd={W:​}%%''​ \\
 +<​code>​
 +http://​192.168.20.113/​set?​cmd={W:​}
 +</​code>​
 +
 +When the command is sent and received successfully the browser should display `OK` and the IP address should disappear from the LCD.
 +\\
 +
 +----
wifi/start.txt · Last modified: 2019/06/22 20:04 by Matthew Upp