User Tools

Site Tools


wifi:start

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
wifi:start [2017/09/08 15:52]
Matthew Upp [NOTES:]
wifi:start [2017/11/24 08:48]
Matthew Upp
Line 1: Line 1:
 ~~NOTOC~~ ~~NOTOC~~
  
-====== Connecting to WiFi ======+====== WiFi ====== 
 + 
 +---- 
 + 
 + 
 +===== Connecting to WiFi =====
   * [[wifi:​android|Android - MP 3D Printer WiFi Connect]]   * [[wifi:​android|Android - MP 3D Printer WiFi Connect]]
   * [[wifi:​ios|iOS - MP 3D Printer WiFi Connect]]   * [[wifi:​ios|iOS - MP 3D Printer WiFi Connect]]
Line 25: Line 30:
  
  
-**Link to firmware, Malyan Link (Windows PC), Malyan 3D Craft (Android):​** [[http://fw.mpselectmini.com|http://​fw.mpselectmini.com]]+**Link to firmware, Malyan Link (Windows PC), Malyan 3D Craft (Android):​** [[http://f.mpselectmini.com|http://​f.mpselectmini.com]] 
 + 
 +----  
 +===== Forget Network ===== 
 +While the MP Select Mini V1/V2 is connected to WiFi you may use the format **''​%%http://​PRINTERS_IP_ADDRESS%%''​** to send a single line of code g-code using a web browsers address/URL bar. See the examples in the following code block. 
 + 
 +**Format:** ''​%%http://​PRINTERS_IP_ADDRESS/​set?​cmd={W:​}%%''​ \\ 
 +<​code>​ 
 +http://​192.168.20.113/​set?​cmd={W:​} 
 +</​code>​ 
 + 
 +When the command is sent and received successfully the browser should display `OK` and the IP address should disappear from the LCD. 
 +\\ 
 + 
 +----
wifi/start.txt · Last modified: 2019/06/22 20:04 by Matthew Upp