Recent Changes

• 2019/10/15 02:50 Power Switch – created Matthew Upp +122 B
• 2019/10/04 06:29 Bowden Coupling – Matthew Upp -222 B
• 2019/10/04 06:27 Belts – Matthew Upp -240 B
• 2019/10/04 06:27 Bearings – Matthew Upp +6 B
• 2019/10/04 06:25 PTFE Tubes – Matthew Upp -467 B
• 2019/10/04 06:21 Replacement Parts – Matthew Upp -1 B
• 2019/10/04 05:52 Power Supply – Matthew Upp -153 B
• 2019/09/28 10:40 Changelog – Matthew Upp +240 B
• 2019/09/28 10:40 Motion Controller Firmware – Matthew Upp +485 B
• 2019/09/28 00:08 Direct Replacement – Matthew Upp -622 B
• 2019/08/20 08:09 Extruder / Feed Mechanism – Matthew Upp +28 B
• 2019/08/20 04:26 Heater Block – Matthew Upp ±0 B
• 2019/07/14 09:57 Cura – Matthew Upp +327 B
• 2019/07/06 22:11 Welcome to the Unofficial Wiki for the MP Select Mini 3D Printer – Matthew Upp -16 B
• 2019/06/22 20:04 WiFi – Matthew Upp +5 B
• 2019/06/02 02:28 Printer Stops or Never Starts Printing – Matthew Upp -291 B
• 2019/05/06 12:09 Donations & Support – Matthew Upp -196 B
• 2019/04/29 08:01 Mods & Improvements – [Bed Expansions] Matthew Upp -71 B
• 2019/04/24 18:51 microSD Card – Matthew Upp +535 B
• 2019/04/02 07:51 M562 - Invert Stepper Motor Direction – Matthew Upp ±0 B
• 2019/03/24 01:03 Starting & Ending G-code Scripts – Matthew Upp -2 B
• 2019/03/23 06:11 Wire Connectors – Matthew Upp +121 B
• 2019/03/18 04:54 Bed Expansions – ↷ Page name changed from thingiverse:4dm to thingiverse:bed_expansions Matthew Upp +202 B
• 2019/03/18 04:54 4dm – ↷ Page name changed from thingiverse:4dm to thingiverse:bed_expansions Matthew Upp -202 B
• 2019/02/18 00:46 Where to Purchase – Matthew Upp +127 B